Skip to content
Clear communicationFree inspections
Call now (570) 555-0192
Scranton, PA (570) 555-0192
Get my free quote
Hillside Scranton neighborhood with brick row homes and shingle roofs in autumn light

River valley rain and closely built blocks

Roofing in Old Forge, PA for valley homes

Leak detection, roof repair, replacement and storm damage work for Old Forge homes in the river valley. Request an estimate to confirm availability.

  • Repairs, re-roofs and storm damage work
  • Houses, row homes and flat commercial roofs
  • Written quote before work begins

Step 1 of 3

What do you need?

Roofs in a river valley borough

Old Forge sits in the Lackawanna valley, with the river close by and hills rising on either side. Streets are tightly built, with doubles, frame houses and corner buildings lined up close together. Many of them have porches, additions and small flat sections, in addition to the main pitched roof.

Valley weather brings heavy rain, damp air and winter cold that settles in low ground. Roofs here deal with long periods of moisture, which wears out sealants and leaves wet patches that dry slowly. A small leak left alone can rot a deck faster than the owner expects.

Porch roofs, additions and low-slope sections

Older houses often have a low-slope porch roof or a rear addition covered in rolled roofing, rubber or tar. These areas collect water, and the joint where they meet the main wall is a common source of leaks. Standard shingles do not belong on very low slopes.

A proper repair uses a membrane meant for low slopes and flashing that laps up the wall and under the siding. We look at these small roofs closely because they are often neglected, even on houses where the main roof is in good shape.

What we can arrange for Old Forge properties

All five services are open to Old Forge addresses, once we confirm availability.

Several of these services overlap, and we will tell you which one matches the problem you describe.

When a valley town gets a long soaking rain, any weak spot is tested. Water seeps under lifted shingles, runs along nails and appears in a ceiling hours later. Damp insulation loses its value and can grow mold if it stays wet.

  • Check the attic during or after rain with a flashlight.
  • Look for dark streaks on rafters and wet insulation.
  • Note which room shows the stain and where it sits in the house.

With this information, a leak detection visit goes faster and costs less.

Photos of the room below the leak, with the date, are very useful when we trace where the water first enters the roof.

Costs, estimates and fair comparison

If you are comparing quotes, line up the details, not just the total. Ask what is included for decking repair, underlayment, flashing, ventilation and clean-up. A low quote that leaves out the deck or the flashing can turn into a higher bill later.

We write our estimates to list the work and the materials, and to name what is not included. That way you can compare us with any other roofer on equal terms. Prices cannot be given over the phone, because the condition of the roof decides much of the cost.

Asking for an estimate in Old Forge

Call (570) 555-0192 about Old Forge, or write to us through the form on the contact page. We serve Old Forge, although we do not have an office in the borough, so your request is how we confirm availability.

  1. Tell us what has happened and where the water shows up.
  2. Say whether the house has a porch roof or an addition.
  3. Share photos of the ceiling, the attic and the roof from the street.
  4. We visit to check the roof and trace the leak.
  5. A written estimate follows, with options if there are any.

If you have noticed the stain growing after rain, mention it, since that points us toward the entry point.

Get a quote in Old Forge

Tell us what you need and we call you back.

Step 1 of 3

What do you need?

No obligation.

Other areas we serve

Questions about Old Forge

Why does my porch roof keep leaking?

Porch roofs often have a very low slope and a joint where they meet the house wall. Old coatings crack, flashing pulls away and water collects. Repair means a membrane suited to low slopes and proper flashing at the wall. Fresh tar alone usually gives only a short fix. We check the joint and the slope.

Can I tell if there is mold in my attic from a roof leak?

Look for dark or fuzzy patches on wood or insulation and a musty smell. Damp insulation that stays wet is a likely place for mold. If you suspect it, stop the leak first, then have the area looked at. We deal with the roof, and a separate specialist handles mold.

How soon should a leak be fixed?

As soon as reasonably possible. Water damage spreads quietly, and wet decking can rot within weeks to months, depending on the conditions. A temporary patch or tarp can protect the house while a proper repair is arranged. Describe the leak in your request so we can judge how urgent it seems.

Does flashing around a chimney wear out faster than shingles?

It often does. Flashing is exposed to movement, weather and the sealant that holds it in place, and old brick chimneys can shift slightly. Re-flashing a chimney during a re-roof is common. Repairs made with sealant alone tend to be short-lived, so we look at the metal and the mortar joints.

Is a flat roof section on a house a problem?

Not by itself. Flat and low-slope roofs work well when the right membrane is used and the edges and drains are well detailed. Problems come from cheap coatings, pooling water and failed seams. We inspect these sections as carefully as the main roof and describe what you can expect. Photos of the joint at the wall help us plan the repair.

Ready when you are

Call now or request a quote online.

Call for a free inspection Get my free quote
(570) 555-0192